We commend you for taking on the exciting challenge to build your own FPV Cinewhoop. There is a level of appreciation received once you assemble your own personalized, cinematic capturing FPV machine, that gives you the ability to fly like a bird! 🦅

The Whoopski v1 was designed to be a simple THREE stage build process. Enjoy!

If you have any questions or need help with your build, jump in the Discord Server or reach out to [email protected]

Needed Tools & Parts:

• Whoopski 3D Prints (STL Files)
• Soldering Iron
• Hex Screwdriver Set (1.3mm - 3mm)
• 60/40 Solder
• Wire Cutters
• Flux Pen

Recommended Drone Components :

• 25.5 x 25.5 AIO Flight Controller/ESC Speedy Bee F405 / GepRC Taker G4 / Lumenier LUX HD G4
• 2004 3000KV (4S) Motors TMotor F2004 3000KV / EMAX ECOII
• Gemfan 76mm 5 Bladed Props / Gemfan 76mm 3 Bladed Props
• BetaFPV ELRS Receiver
• DJI 04 Pro FPV System

Other Recommended Components :

• Smoke Stopper
• **RadioMaster Boxer or Pocket Transmitter**
• 1300MAH 4S Lipo Batteries (XT-60)
• DJI FPV Goggles (Integra)
• Heat Gun

Stage One: Install Components on Bottom Plate

Difficulty: Medium

Stage One requires basic soldering skills, don’t be intimidated! 😇

If you are a noob to soldering here are some tips:

Soldering Tips